Pathology storage cabinets · paraffin blocks, microscope slides & archives
Luoyang, Henan, China Sales: +86 139 3881 2326

Tender Specification Checklist for Pathology Storage Cabinets

Turn a cabinet requirement into clauses a supplier can answer and an evaluator can compare: dimensions, capacity arithmetic, steel, runners, internals, locks and delivery terms.

Procurement & Specification | 2026-09-19 | Luoyang Guanting Office Furniture Co., Ltd.

A cabinet tender that says “steel storage cabinet, drawers as required” produces offers that cannot be compared. The clauses below are the ones that decide the outcome, written so each can be answered with a number rather than an adjective.

1. Dimensions and capacity

ClauseSpecify
Section width450 mm or 515 mm, stated as a minimum or exact value
Section heightStated per section, with total group height for the required section count
Drawer countDrawers per section and sections per group, e.g. “18 drawers per section, 4 sections, 72 drawers per group”
CapacityTotal capacity and the per-drawer figure, with the cassette or slide format assumed

Asking for both the total and the per-drawer figure prevents the common situation where two offers state the same total from very different drawer configurations.

2. Steel and construction

  • Steel type and thickness by part — body, drawer front, drawer body — as measured values, not “high quality steel”.
  • Welding method: folded and welded corners rather than spot-welded.
  • Surface treatment: degrease, phosphating, electrostatic powder coating; coating resistant to routine disinfectants.
  • Base: adjustable feet and a shared base for stacked groups.

3. Drawers and runners

  • Runner type: three-section, full extension, with a stated load rating above the full-drawer weight.
  • Internal structure: divider count or slot count, matched to the format stated in the tender.
  • Stop and anti-tip feature: drawer must not leave the runner under normal full extension.

4. Labelling and access

  • Label holder on every drawer front, plus a numbered position inside the drawer.
  • Lock level: state whether cabinet-level or per-drawer, and whether a master key is required.

5. Delivery and acceptance

  1. Packing method and whether freight, unloading and installation are included.
  2. Drawings for approval before production, with a revision date.
  3. Acceptance test: load one drawer to stated capacity, extend fully, hold five minutes, measure drop.
  4. Spare parts delivered with the order: runners, locks, label holders.
  5. Warranty start date at acceptance, and response times for service.

What to require in the response

Ask each bidder for a clause-by-clause response table plus a dimensioned drawing and the capacity calculation. A bidder who returns a catalogue page instead of a response table has not answered the tender, however good the catalogue looks.

For the technical values themselves, see steel cabinet specification and capacity calculation.

Need a cabinet for a specific room? Call +86 139 3881 2326 or send the dimensions — we will return a section and drawer plan.

Need cabinets sized to your archive room?

Send your room dimensions and archive volume — we will return a drawer layout, section count and quotation.