Pathology storage cabinets · paraffin blocks, microscope slides & archives
Luoyang, Henan, China Sales: +86 139 3881 2326

Steel Cabinet Specification: Thickness, Welding, Coating and Runner Load

Why 0.8 mm is a floor rather than a target, how welding and folding affect rigidity, what powder coating actually protects, and how to state runner load so it can be verified.

Procurement & Specification | 2026-09-20 | Luoyang Guanting Office Furniture Co., Ltd.

Steel specification clauses are where tenders most often become unverifiable. “high-quality cold-rolled steel” tells an evaluator nothing; a thickness by part plus a welding method plus a coating process can be checked at delivery.

Thickness by part

PartTypical rangeComment
Cabinet body0.7–1.0 mmFolded edges matter more than raw thickness
Drawer front0.8–1.0 mmShould be formed with the drawer body, not screwed on
Drawer body0.8–1.2 mmLoad-bearing; heavier where drawers are deep

0.8 mm is best treated as a minimum, not a target. A 0.8 mm drawer with folded edges and a correct runner outperforms a 1.0 mm flat drawer with a weak runner, because stiffness comes from geometry as much as from gauge.

Welding and folding

  • Folded corners resist racking when a group is stacked four sections high.
  • Continuous or stitch welding at corners keeps sections square; spot welds at the corners alone tend to open under load.
  • Reinforcing returns on drawer fronts stop the front bowing when the drawer is full.

Coating

Powder coating is applied after degreasing and phosphating. The pre-treatment is what prevents rust under the coating; skipping it produces a cabinet that looks fine and rusts from a scratch within a year. Specify:

  1. Degrease and phosphate pre-treatment.
  2. Electrostatic powder coating, cured at the manufacturer's stated temperature.
  3. Resistance to routine disinfectants — alcohol and chlorine-based wipes are common in pathology.

Runner load

State the load rating as a number that exceeds the full-drawer weight. A full block drawer is roughly 5–7 kg; a full slide drawer 4–5 kg. A runner rated at 15–20 kg gives margin; one rated at 5 kg does not, whatever the cabinet thickness.

Verification at acceptance: load one drawer to stated capacity, extend fully, hold for five minutes, measure the drop at the front edge. Anything over 2–3 mm indicates the runner is under-rated for the load.

See the tender checklist for how to word these clauses, and model data for the values we publish.

Need a cabinet for a specific room? Call +86 139 3881 2326 or send the dimensions — we will return a section and drawer plan.

Need cabinets sized to your archive room?

Send your room dimensions and archive volume — we will return a drawer layout, section count and quotation.