Pathology storage cabinets · paraffin blocks, microscope slides & archives
Luoyang, Henan, China Sales: +86 139 3881 2326

Drawer Configuration Guide: Cassette Dividers and Slide Slots

How divider spacing and slot count are set, why they cannot be swapped between blocks and slides, and what to send a supplier so the drawer arrives ready for your format.

Selection Guides | 2026-09-07 | Luoyang Guanting Office Furniture Co., Ltd.

Two cabinets can look identical from the front and behave completely differently once loaded, because the drawer internals were configured for a different cassette or slide format. This guide covers what to specify.

Paraffin block drawers

A block drawer is divided into rows. The number of rows and their spacing set the capacity, and the spacing has to suit the cassette width.

Cassette typeApprox. widthApprox. thicknessSuggested divider spacingBlocks per drawer
Standard cassette28 mm5–6 mm30–32 mm500–600
Small cassette25 mm5 mm27–28 mm600–700
Deep cassette28 mm7–8 mm30–32 mm400–500

Note that a deeper cassette does not need wider spacing — it needs more length per row. Deep cassettes reduce capacity because fewer fit front to back, not because the rows get wider.

Slide drawers

Slide drawers use slots rather than rows. Slot pitch is typically 2.4–3.0 mm, which allows a slide plus its coverslip to enter without binding. Slot depth should reach 70–80% of the slide height so the slide stands upright but the label remains visible.

  • Slot count per drawer depends on drawer width: a 450 mm drawer carries roughly 300–400 slots; a 515 mm drawer roughly 350–450.
  • A finger notch at the front lets the technician lift the slide by its label end.
  • Slot bottoms must be flat and burr-free; a burr scratches the lower edge of the slide.

Three questions to send with an enquiry

  1. What are the exact dimensions of the cassette or slide you use, including thickness?
  2. How many cassettes or slides must one drawer hold, and is that a hard requirement?
  3. Is the drawer expected to hold mixed formats, and if so, which is dominant?

With those answers a supplier can state the row count, slot count and per-drawer capacity in the quotation, and the capacity figure becomes checkable rather than decorative.

What not to do

  • Do not mix cassette thicknesses in one row. Thin and thick cassettes together make the row lean, and the drawer binds when pulled.
  • Do not use a slide drawer for blocks. The drawer is too shallow and has no load structure for the weight.
  • Do not accept friction-fit dividers on a heavily used cabinet. They drift; welded or riveted dividers keep their spacing.

Related reading: how many cassettes fit per drawer and how many slides fit per drawer.

Need a cabinet for a specific room? Call +86 139 3881 2326 or send the dimensions — we will return a section and drawer plan.

Need cabinets sized to your archive room?

Send your room dimensions and archive volume — we will return a drawer layout, section count and quotation.