Most stiff drawers are caused by dirt in the runner, a cabinet out of level, or material jammed behind the drawer — in that order. A five-minute diagnosis before calling for parts.
FAQ & Troubleshooting | 2026-09-18 | Luoyang Guanting Office Furniture Co., Ltd.
A drawer that suddenly runs rough is usually not a broken runner. Work through these four causes in order before ordering parts.
Cassettes and slides slip behind drawer backs more often than people expect. Remove the drawer completely and inspect the runner channel and the space behind the cabinet face. A single fallen cassette can stop a drawer dead.
Dust mixed with lubricant forms a hard paste that raises friction progressively — the classic “it gets harder every month” pattern. Clean the runner channel with a vacuum and a dry brush, then apply a very small amount of light grease. Do not use cooking oil or general-purpose oil: it attracts dust and can migrate into the drawer.
| Symptom | Likely cause | Action |
|---|---|---|
| Front edge lower than the cabinet face | Runner overloaded or deformed | Check load; replace runner if drop exceeds 2–3 mm |
| Drawer rubs the drawer below | Runner fixing screws loose | Tighten; if holes are elongated, replace runner |
| Drawer binds only at the end of travel | Runner not parallel | Re-align runner pair before tightening |
| Drawer wobbles when open | Ball cage damaged | Replace runner pair |
Replace the runner pair when the cage is damaged, when the drop exceeds 2–3 mm with a correctly loaded drawer, or when the same drawer has needed tightening twice in a year. Always replace both runners of a pair — a new runner against a worn one will bind.
Spare runners, locks and label holders are supplied with orders; ask for the runner model when reordering. Related: what to check when buying.
Usually one of three things: a cassette or slide has fallen behind the drawer, the runner channel has accumulated dust and hardened grease, or the cabinet has gone out of level. Check one drawer against the rest to narrow it down.
Yes, with a small amount of light grease after cleaning. Avoid oils that attract dust and never use cooking oil; excess lubricant collects debris and makes the problem worse.
Under 2 mm at full extension with a correctly loaded drawer is normal. Beyond 3 mm the runner is usually overloaded or deformed and should be replaced as a pair.
Need a cabinet for a specific room? Call +86 139 3881 2326 or send the dimensions — we will return a section and drawer plan.
Send your room dimensions and archive volume — we will return a drawer layout, section count and quotation.