Mould in an archive is a humidity problem before it is a cabinet problem. Target relative humidity, keep the cabinet off the floor, dry slides before filing and know what to do with affected material.
FAQ & Troubleshooting | 2026-09-15 | Luoyang Guanting Office Furniture Co., Ltd.
Mould in a pathology archive almost always traces back to moisture, and the moisture usually comes from the room rather than from the cabinet. Treating the cabinet alone rarely solves it.
| Measure | Effect |
|---|---|
| Base lifting the cabinet 10–15 mm off the floor | Reduces moisture drawn from a damp floor |
| Powder-coated steel body | Prevents rust and condensation staining |
| Drawers closing flush | Limits humid air exchange inside the cabinet |
| Cabinet alone in a 75% RH room | Not sufficient; room dehumidification is required |
Seasonal humidity control is worth planning for: a small dehumidifier with continuous drainage is more reliable than one that fills a tank daily. See the drying cabinets for the flat-drying step, and drying cabinet placement.
Between 40% and 60% relative humidity at 18–25 °C. Above 65% mould risk rises sharply; below 30% coverslip mounting medium may become brittle. Record humidity in the room, not only inside the cabinet.
Small desiccant packs can help locally, but they are a supplement, not a substitute for room humidity control. Replace them on a schedule and keep them out of direct contact with slides.
Remove them from the archive, dry them in a controlled space, and have a pathologist decide whether they remain diagnostic. Clean and re-coverslip where possible; re-cut from the block where not. Then address the humidity source before restocking.
Need a cabinet for a specific room? Call +86 139 3881 2326 or send the dimensions — we will return a section and drawer plan.
Send your room dimensions and archive volume — we will return a drawer layout, section count and quotation.